Choose to receive your door either unfinished or opt for our pre-finishing service. You can select from clear, light, medium or dark oak.

We will spray your door with 2 coats of a super tough matt clear finish, with your door carefully sanded between coats. Each coat will be infrared cured in a drying tunnel. The result is a superb finish that is much better than can be achieved by brush finish and will more closely match other prefinished doors you may already have.

You can also buy these doors unfinished. They can be treated with either water or solvent based finishes but care should always be taken to not saturate the door when applying the first coat of any finish.

This can cause the veneer to lift as the saturated veneer swells and breaks the glue bond, forming a ‘bubble’ in the veneer. Should this happen, its best to first leave the door to dry out for 2-3 weeks as the bubble will usually disappear as the veneer dries and shrinks back.

If bubbles remain the sitation can be resolved by puncturing the bubble, squeezing a small amount of PVA glue into the cavity and with the door lying flat, leave a weighted block on the bubble over a plastic sheet so the block doesn’t stick. This will flatten back the bubble which can then be sanded and refinished once the glue has set.